Series 6 Players
XD236, XD1036
XD6 Theory of Operation
5 min
this section describes how specific components operate on the xd236 and xd1036 on board leds the four on board leds have the following indicators true 330,331left unhandled content type left unhandled content type left unhandled content type left unhandled content type left unhandled content type left unhandled content type left unhandled content type left unhandled content type left unhandled content type left unhandled content type on board switch / svc button the service (svc) button provides a dedicated gpio button (gpio12) for the os pressing the svc button pulls the pin low conversely, releasing the button pulls the pin high reset switch / gpio button the reset button is connected to the reset circuit pressing the reset button will send an initial signal to the system software and holding the reset button low for approximately six seconds will cause a hard reset microsd slot the xd236 and xd1036 have two sd ports, one external and one internal the internal sd card reader will support speeds up to sdr104, while the external sd card reader will support speeds upto ddr50 there is no inherent limit on the storage capacity of microsd cards used with the player wireless module the xd236 and xd1036 have a dual antenna connection which allows users to install a brightsign wireless module brightsign modules are configured to work with 802 11 n or 802 11 ac access points the wireless module also offers bluetooth functionality cellular modem the xd236/xd1036 are fitted with a b key m 2 connector which supports 4230 form factor m 2 cards for cellular modem (usb interface) connectivity the recommended card is the quectel em05 g iot/m2m optimized lte cat 4 module the external sma connectors can be used to mount two 4g/5g antennas appropriate for the region of intended use two internal cables with appropriate connectors will need to be sourced to connect the card to the antennas a nano size sim card socket is located on the pcb assembly note that cellular modem cards with components on the rear will not fit