Access Point Mode

previously, if you want to set up a player through on player setup docid\ cdghye6qgy irnh5kazx6 , provisioning, or activation, you first needed an ethernet connection to the cloud now, you can set up a wifi only player with access point mode first use the access point setup screen to connect to your local network, and then you can access activation , provisioning , or on player setup note that you will need to use either a factory fresh player or factory reset an existing player (it must have a blank microsd card) this player must also be running brightsignos 8 4 x or higher and have an installed wifi module to set up a player factory reset a player docid\ yncf7p2pyzo2qedf1jyim the player after the player reboots (about 60 seconds), you will see the wireless access point setup screen follow the on screen instructions connect your computer or mobile device for example, on a pc, go to network & interface settings > wi fi to select the brightsign player, and then select connect start your browser and enter the ip address on the screen (e g , http //192 168 10 200/setup in the image below) this will take you to the brightsign player setup page follow the instructions on the page to set up your device for wifi (you will have to enter the network name and your wifi password) once the pc/mobile connection is established, the player will reboot now you can select activation , provisioning , or on device setup activation enter the activate docid\ oof rmqhqfvlhokxi8ypj in brightauthor\ connected see image below this will automatically download and install the default provisioning setup from b deploy provisioning if a provisioning record was configured for the player, it will automatically download it from b deploy and install it note that the provisioning record must be added to brightauthor\ connected before you setup the player for the player to receive the record from cloud se provision docid\ cyl9kpm02co5rgcb9wqqv for more info on player setup enter the on player setup docid\ cdghye6qgy irnh5kazx6 for on player setup by going to http ///setup this screen will appear immediately if you are not connected to the internet the on player setup feature is supported on series 4 (xtx44, xdx34, hdx24, ls424) and series 3 (xtx43, xdx33, hdx23, ls423) models only you should be able to see all the available network types in the ui and most will be enabled this is expected, but if you choose any network setup other than wifi or "use current network settings", the connection will fail without adding the corresponding physical connection, (for example, the ethernet cable)